Table of Contents
Advertisement
Chapter 21
set port mirror Fabric_mode2
Command Mode
Description
Syntax
21-26
Global Configuration.
Set up or remove a port mirror on a switch in Fabric mode 2.
To Configure:
set port mirror Fabric_mode2 source-port <mod-port-
range> mirror-port <mod-port-spec> channel <channel>
direction {tx | rx | both | sa | da} sampling {always | disable
| periodic} [sa <MAC-address>] [da <MAC-address>]
[max-packets-sec <max-packets-sec-value>]
To Clear:
clear port mirror Fabric_mode2 channel <channel>
Table 21-23. Parameters, Keywords, Arguments
Parameter
Definition
<mod-port-
Either the single port or the range of ports that you want to
range>
mirror. See
can mirror.
<mod-port-
The port to which you want to mirror traffic.
spec>
Both the source port and mirror port must either:
Note: Avaya recommends that you mirror traffic to a port of
<channel>
The mirror channel that you want to use. Four channels are
available. Enter a number from 1 to 4.
{tx | rx | both | sa
The direction of traffic that you want to mirror or the MAC
| da}
address filter that you want to use. If you enter sa or da, the
switch monitors both transmit and receive traffic.
Note: You can mirror transmit traffic of only one source port
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Table 21-24
for the specific port ranges that you
• Be on the same vlan and have the same vlan binding
or
• Have vlan binding set to bind to all
the same speed or faster than the source port.
to the mirror port. You cannot mirror transmit traffic
of multiple source ports to one mirror port.
1 of 2
Advertisement
Table of Contents
