Table of Contents
Advertisement
Chapter 11
ip routing-mode
Command Mode
Description
Syntax
Sample Output
Systems
11-44
Interface Configuration.
Sets the IP routing mode on an interface. The no form of this command
restores the default setting of RT_MGMT.
To Configure:
To Restore
Default:
Table 11-22. Parameters, Keywords, Arguments
Name
{RT_MGMT |
RT_ONLY |
MGMT_ONLY}
This example enables local packet consumption and disables IP forwarding
on an interface labeled "boston".
(config-if:boston)# ip routing-mode MGMT_ONLY
P550R, P580, P880, and P882.
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
ip routing-mode {RT_MGMT | RT_ONLY |
MGMT_ONLY}
no ip routing-mode
Definition
• Routing/Mgmt - IP routing is enabled on the
interface, and you can manage the switch
through the interface (from the CLI or Web
Agent).
• Mgmt Only - You can manage the switch
through the interface (from the CLI or Web
Agent), but IP routing is disabled on the
interface.
Note: Do not enable routing protocols on an
interface configured for Mgmt Only since the
interface will act as an end point and will not
pass traffic.
• Routing Only - Routing only interfaces do
not permit management traffic destined for
local interfaces but do allow all other traffic
including management traffic destined for
interfaces on other switches.
Advertisement
Table of Contents
