Table of Contents
Advertisement
area default-cost
Command Mode
Description
Syntax
Sample Output
Systems
Document No. 10-300090, Issue 1
OSPF Router Configuration.
Defines the cost for routes advertised into stub area by an area border router.
To restore the default value, use the no form of this command. The valid
range is 1 to 65535. The default setting is 1.
To Configure
To Restore Default:
Table 19-3. Parameters, Keywords, Arguments
Name
Definition
<area-id>
A decimal value or IP address that identifies an OSPF area.
<cost>
A cost value of the area. The valid range is 1 to 65535. The
default setting is 1.
The following command sets an area default cost of 3 on OSPF set on the
specified router.
(configure router:ospf)# area 2.0.0.0 default-cost 3
The following command removes an area default cost from OSPF set on the
specified router.
(configure router:ospf)# no area 2.0.0.0 default-cost
P550R, P580, P880, and P882.
area <area-id> default-cost <cost>
[no] area <area-id> default-cost
OSPF
19-5
Advertisement
Table of Contents
