Set Port Point-To-Point Admin Status - Avaya 106760804 Command Reference Manual

set port point-to-point admin status

Command Mode
Description
Syntax
Systems
Document No. 10-300090, Issue 1
Global Configuration.
Specifies whether a port is connected to a shared LAN segment or a point-
to-point LAN segment. A point-to-point LAN segment is connected to
exactly one other bridge (normally with a direct cable between them). Only
point-to-point links and edge ports can rapidly transition to forwarding
state.
If you set this field to Auto, the switch automatically detects whether the
port is connected to a shared link or a point-to-point link. Ports operating in
half duplex are set to non-point-to-point, and ports operating in full duplex
are set to point-to-point. You can, however, manually set the type of link.
set port point-to-point admin status {<mod-num> | <mod-swport-range>}
[...,{<mod-num> | <mod-swport-range>}] {force-true | force-false | auto}
Table 28-2. Parameters, Keywords, Arguments
Name Definition
<mod-swport- The module and port or port range.
range>
force-true Defines the port as connected to a point-to-point link.
force-false Defines the port as connected to a shared LAN segment.
auto Automatically detects whether the port is connected to a
shared link or a point-to-point link. Ports operating in half
duplex are set to non-point-to-point, and ports operating
in full duplex are set to point-to-point
If you select this setting, the OperPointToPoint field of
the show port command displays the link type that is
detected.
P580 and P882.
Rapid Spanning Tree Protocol
28-3