Table of Contents
Advertisement
Chapter 24
set radius authentication source-ip
Command Mode
Description
Syntax
Sample Output
Systems
24-8
Global Configuration.
Sets the IP interface address the switch will use as the source IP address in
the Access Request messages. This value must be an IP interface address on
the switch. If set, and the IP interface becomes disabled, RADIUS will not
function because the switch will not be able to send or receive RADIUS
messages.
If left 0.0.0.0 (the default), the switch automatically selects a source IP
address from one of its active interfaces. If you use this setting, you must
add each of the switch IP addresses to the Client file on the RADIUS server
since you are not manually setting the source IP address.
To Configure
set radius authentication source-ip <ip-addr>
To Clear
clear radius authentication source-ip
Table 24-6. Parameters, Keywords, Arguments
Name
Definition
<ip-addr>
IP address that is used as the source IP address for Access Request
messages.
The following command sets the source IP address to 192.168.1.1:
(configure)# set radius authentication source-ip 192.168.1.1
P550R, P580, P880, and P882.
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Advertisement
Table of Contents
