Set Port Flow-Control - Avaya 106760804 Command Reference Manual

set port flow-control

Command Mode
Description
Syntax
Sample Output
Systems
Document No. 10-300090, Issue 1
Global Configuration.
Set the port flow control.
* Note: Setting this parameter on any M5548-100TX port sets all
physical ports on the module to the same value.
set port flow-control {<mod-num> | <mod-port-range>}[...,{<mod-num> |
<mod-port-range>}] {disable | enable | enable-receive-only | enable-send-
only | enable-with-aggressive-backoff}
Table 21-15. Parameters, Keywords, Arguments
Name
<mod-num>
<mod-port-range>
{disable | enable |
enable-receive-only |
enable-send-only |
enable-with-
aggressive-backoff}
The following example sets the flow control on all the gigabit ports on the
module in slot 3 to enable-receive-only.
(configure)# set port flow-control 3 enable-receive-only
Port flow control set: 3/1,3/2
P550R, P580, P880, and P882.
Definition
Specifies the number of the module where the flow control
for each port on the module is to be set.
Specifies the range of ports whose flow control is to be set.
The flow control options are:
• disable - Disables flow control for specified ports.
Turns off an attached device's ability to send flow-
control packets to a local port.
• enable - Enables flow control for specified ports.
Turns on an attached device's ability to send flow-
control packets to a local port.
• enable-receive-only - Enables receive only for the
specified gigabit ports. Indicates that a port only
receives administrative status from a remote device.
• enable-send-only - Enables send only for the
specified gigabit ports. Indicates that a port only
sends administrative status from a remote device.
• enable-with-aggressive-backoff - Enables flow
control with aggressive backoff for specified fast
ethernet ports.
Port
21-17