Chapter 6
CLI – Layer 2
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
set intermodule port redundancy off
Use the set intermodule port redundancy off command to clear the
intermodule redundancy scheme.
The syntax for this command is:
set intermodule port redundancy off
set port mirror
Use the set port mirror command to define a port mirroring source-
destination pair in the stack.
The syntax for this command is:
set port mirror source-port <mod_num>/<port_num> mirror-port
<mod_num>/<port_num> sampling {always|disable} direction
{rx|tx|both}
always
disable
rx
tx
both
Output Example:
P330-N# set port mirror source-port 1/9 mirror-port 1/10
sampling always direction both
Mirroring both Rx and Tx packets from port 1/9 to port 1/10 is
enabled
set port spantree
Use the set port spantree command to enable or disable the spanning tree
mode for specific switch ports.
120
Keyword to activate the port mirroring entry
Keyword to change the status of the port mirroring entry to "not active"
Keyword to copy only incoming traffic
Keyword to copy only outgoing traffic - Not supported in P330 switches
Keyword to copy both incoming and outgoing traffic
Avaya P334T-ML User's Guide