Set Port Mirror - Avaya P333R User Manual

set port mirror

Use the set port mirror command to define a port mirroring source-
destination pair in the stack.
The syntax for this command is:
set port mirror source-port <mod_num>/<port_num> mirror-port
<mod_num>/<port_num> sampling {always|disable} direction
{rx|tx|both}
always
disable
rx
tx
both
Output Example:
P330-N# set port mirror source-port 1/9 mirror-port 1/10
sampling always direction both
Mirroring both Rx and Tx packets from port 1/9 to port 1/10 is
enabled
set port spantree
Use the set port spantree command to enable or disable the spanning tree
mode for specific switch ports.
The syntax for this command is:
set port spantree {enable|disable} [module/port]
enable|disable
module/port
Output Example:
Enable the spanning tree mode for port 2 on module 3.
P330-N# set port spantree enable 3/2
Avaya P333T-PWR User's Guide
Keyword to activate the port mirroring entry
Keyword to change the status of the port mirroring entry to "not active"
Keyword to copy only incoming traffic
Keyword to copy only outgoing traffic
Keyword to copy both incoming and outgoing traffic
Enables or disables the spanning tree mode for the
specified ports.
The switch/port number.
Chapter 5 CLI – Layer 2
105