Table of Contents
Advertisement
appletalk static cable-range
Command Mode
Description
Syntax
Document No. 10-300090, Issue 1
Global Configuration.
Creates an Appletalk static route. The no form of this command removes
the static route itself, or only removes a zone from the static route if the
zone name is supplied.
To Enable:
appletalk static cable-range <cable-range> to
<network.node> [floating] zone <zone-name>
To Disable:
[no] appletalk static cable-range <cable-range> to
<network.node>
Table 3-8. Parameters, Keywords, Arguments
Name
Definition
<cable-range>
The range of Appletalk network values to be used for this
static route. Specify start and end values, in decimal, between
0 and 65279 and separate the values with a hyphen.
The starting network number must be less than the ending
network number. The next hop Appletalk router is specified
via the network.node parameter.
<network.node>
Specifies the Appletalk Network Address of the next hop to
the destination network. (Both numbers are in decimal.)
[floating]
Specifies that a dynamic route update for this network can
replace the route entry created by this command.
The floating argument is optional. If supplied, the route
defined via this command may be overwritten by an
Appletalk routing update. The default is to ignore Appletalk
route updates for this cable range.
<zone-name>
A zone name to be associated with this destination.
When the keyword zone and the zone-name are omitted, the
static route is removed.
• network - A 16-bit network number between 0 and
66279.
• node - An 8-bit node number between 0 and 254.
Appletalk
3-11
Advertisement
Table of Contents
