Lacp Commands - D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
The LACP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config lacp port_priority
show lacp
Each command is listed in detail, as follows:
config lacp port_priority
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the LACP priority of a port:
show lacp
Purpose
Syntax
Description
Parameters
161
Parameter
<portlist> [priority 1-65535] [timeout <90sec | 3sec>]
{<portlist>}
To set the priority value of a physical port in an LACP group.
config lacp port_priority <portlist> [priority 1-65535] [timeout
<90sec | 3sec>]
The config lacp port_priority command sets the LACP priority
value and administrative timeout of a physical port or range of ports
in an LACP group.
<portlist> - A port or range of ports to be configured.
<priority 1-65535> - Specifies the LACP priority value for a port or
range of ports to be configured. The default is 1.
<timeout> - Specifies the administrative LACP timeout.
•
90sec – Specifies the LACP timeout to be 90 seconds. This
is the default.
•
3sec – Specifies the LACP timeout to be 3 seconds.
Only Administrator or operator-level users can issue this command.
DGS3100# config lacp port_priority 1 priority 2
Success.
DGS3100#
To display current LACP port mode settings.
show lacp {<portlist>}
The show lacp command displays the current LACP mode settings.
<portlist> - A port or range of ports whose LACP settings are to be
displayed.
If no parameter is specified, the system displays the current LACP

LACP COMMANDS

29