D-Link xstack DGS-3620 series Reference Manual page 179

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To display an aggregate route of 10.0.0.0/8:
DGS-3620-28PC:admin#
Command: show bgp aggregate_address 10.0.0.0/8
Network Address
------------------
10.0.0.0/8
Total Aggregate Address Number: 1.
DGS-3620-28PC:admin#
12-11 create bgp network
Description
This command is used to specify the network advertised by the Border Gateway Protocol (BGP).
BGP networks can be learned from connected routes, from dynamic routing, and from static route
sources.
Format
create bgp network [<network_address> | ipv6 <ipv6_networkaddr>] {route_map
<map_name 16>}
Parameters
<network_address> - Represents the local network that BGP will advertise.
ipv6 – Specifies the local IPv6 network that BGP will advertise.
<ipv6_networkaddr> - Enter the IPv6 network address here.
route_map - (Optional) Specifies the route map to be applied to the advertised networks. If not
specified, all networks are advertised.
<map_name 16> - Enter the route map name here. This name can be up to 16 characters
long.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
Setup network 10.108.0.0/16 to be included in the BGP updates:
DGS-3620-28PC:admin#
Command: create bgp network 10.108.0.0/16
Success.
DGS-3620-28PC:admin#
show bgp aggregate_address 10.0.0.0/8
Options
----------------------
summary_only, as_set
create bgp network 10.108.0.0/16
174