D-Link xstack DGS-3620 series Reference Manual page 203

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config bgp client_to_client_reflection [enable | disable]
Parameters
enable - The reflector will operate in reflector mode.
disable - The reflector will operate in non-reflector mode.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
This example shows how to disable the client to client reflection:
DGS-3620-28PC:admin#
Command: config bgp client_to_client_reflection disable
Success.
DGS-3620-28PC:admin#
12-32 config bgp confederation identifier
Description
This command is used to configure the BGP confederation. A confederation, which is represented
by an AS, is a group of the sub AS.
A confederation can be used to reduce the internal BGP (iBGP) mesh by dividing a large single AS
into multihop sub AS. External peers interact with the confederation as if it is a single AS.
Each sub AS is fully meshed within itself and it has connections to other sub AS within the
confederation. The next hop, Multi Exit Discriminator (MED), and local preference information is
preserved throughout the confederation, allowing you to retain a single Interior Gateway Protocol
(IGP) for all the autonomous systems.
Format
config bgp confederation identifier <as_number 0-4294967295>
Parameters
<as_number 0-4294967295> - Autonomous System numbers which we use to specify a BGP
confederation. If it is set to zero, the BGP confederation number is deleted. By default, this
setting is zero. This value must be between 0 and 4294967295.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
config bgp client_to_client_reflection disable
198