Excluding A Port From The Shutdown Action Upon Detection Of Multi-Active Collision - HP 5130 EI series Configuration Manual

Create an ND MAD VLAN and assign the ports on the ND MAD links to the VLAN.
If the intermediate device is also an IRF fabric, assign the two IRF fabrics different domain IDs
for correct split detection.
To configure ND MAD:
Step
1. Enter system view.
2. Assign a domain ID to the IRF
fabric.
3. Configure the IRF bridge
MAC address to change as
soon as the address owner
leaves.
4. Create a VLAN dedicated to
ND MAD.
Return to system view.
5.
6. Enter Ethernet interface view.
Assign the port to the ND
7.
MAD VLAN.
8. Return to system view.
9. Enter VLAN interface view.
10. Assign the interface an IP
address.
11. Enable ND MAD.
Excluding a port from the shutdown action upon detection of
multi-active collision
By default, all ports (except the console and IRF physical interfaces) shut down automatically when the
IRF fabric transits to the Recovery state.
You can exclude a network port from the shutdown action for management or other special purposes. For
example:
Exclude a port from the shutdown action so you can Telnet to the port for managing the device.
•
Command
system-view
irf domain domain-id
undo irf mac-address persistent
vlan vlan-id
quit
interface interface-type
interface-number
•
Assign the port to the VLAN as an
access port:
port access vlan vlan-id
•
Assign the port to the VLAN as a
trunk port:
port trunk permit vlan vlan-id
•
Assign the port to the VLAN as a
hybrid port:
port hybrid vlan vlan-id { tagged |
untagged }
quit
interface vlan-interface
vlan-interface-id
ipv6 address
{ ipv6-address/pre-length | ipv6
address pre-length }
mad nd enable
31
Remarks
N/A
The default IRF domain ID is 0.
By default, the IRF bridge MAC
address remains unchanged for
6 minutes after the address
owner leaves.
The default VLAN on the device
is VLAN 1.
N/A
N/A
The link type of ND MAD ports
can be access, trunk, or hybrid.
The default link type of a port is
access.
N/A
N/A
By default, no IPv6 address is
assigned to any VLAN interface.
By default, ND MAD is disabled.