Service Data And Response Data - Omron NY532-5400 User Manual

8 CIP Message Communications
8-2-6

Service Data and Response Data

CIP communications instructions send and receive data that is stored in array variables.
Preparing Array Variables to Input and Output Service Data and
Response Data
This section describes the array variables for storing service data and response data that CIP commu-
nications instructions send and receive.
 Creating Array Variables
To input a value into the array variable of a CIP communications instruction, you must create a vari-
able with the same configuration as the array variable in advance.
Example: Creating a Variable to Input Data to the CIPSend Instruction Array Variables
Variable A
(1)
Variable B
(2)
Variable C
(1) Input the service data to send.
The data to send is stored in array
variable A. If only certain elements are spec-
ified in array variable A, specify the number
of elements in variable B.
Array variable: A
[0]
[1]
[2]
[3]
If the service data (ServiceDat) is
Array[2] and number of elements
(Size) = 2, Array[2] and Array[3]
are sent.
8-14
CIP communications instruction
CIPSend
ServiceDat
(Command Data)
Size
(Number of Elements)
RespSize
(Response
Data Size)
ResServiceDat
(Response Data)
Number of elements: 2
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
Variable D
(2) The data that is received is stored in vari-
able C. The byte size of the data that was
actually received is stored in variable D.
Array variable: C[0..9]
[0]
[1]
[2]
[3]
[4]
Variable D
[5]
: 10
[6]
[7]
[8]
[9]