Online Connection - Omron NY532-5400 User Manual

4 Determining IP Addresses
4-2-3

Online Connection

Connect the Sysmac Studio online to the Controller.
Types of Connections between the Controller and Computer That
Runs the Sysmac Studio
The Controller and the computer that runs Sysmac Studio are connected as shown below via USB or
Ethernet:
Ethernet Connection
Direct Connection via Ethernet (1:1 Connection
Note 1 An Ethernet switch is not necessarily required.
2 You can use a straight or cross Ethernet cable
to connect.
Connection from USB Across Ethernet
Remote Connection via USB (1:N Connection)
USB
Note 1 An NJ/NX-series Controller with a USB port is
required to connect.
2 An Ethernet switch is required to connect. Refer to
2-1-4 Precautions for Ethernet Switch Selection for
details.
Additional Information
• Auto IP automatically assigns IP addresses in Windows 98 and later operating systems.
Unique IP addresses are automatically assigned from the address 169.254.0.0 to
169.254.255.255.
• If the IP address of the connected EtherNet/IP port is changed when the Sysmac Studio is
connected online via a built-in EtherNet/IP port, a timeout will occur in the Sysmac Studio. In
the case, switch the Sysmac Studio status to offline, change to the IP address of the con-
nected built-in EtherNet/IP port, and then switch back the Sysmac Studio status to online. This
will allow you to reconnect.
4-8
with AutoIP)
Ethernet
Ethernet
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
Ethernet Connection via Hub (1: N Connection)
Ethernet
Note An Ethernet switch is required to connect. Refer
to 2-1-4 Precautions for Ethernet Switch Selec-
tion for details.