Controller Status - Omron NY532-5400 User Manual

7 Tag Data Link Functions
Example: Using an NY-series Controller to send the Target PLC Operating Mode of the Target Node
with an IP Address of 192.168.250.2
IP address = 192.168.250.2
Value of last byte = 2
Target ID = #002
NY-series Controller

Controller Status

Variable a
Variable b
Variable c
Additional Information
The target ID may be duplicated depending on the IP addresses of the target nodes. In this case,
it is necessary to change the target ID with the Network Configurator so that the same address is
not used twice. For information on how to change the target node ID, refer to step 4 under 7-2-5
Connection Settings.
7-10
_EIP_TargetPLCModeSta (Target PLC Operating Mode)
Controller status
Controller status (when included)
Output tag set
Connection
EtherNet/IP
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
0
1
2
254
255
CJ-series CPU Unit
Controller status
I/O memory
Input tag set
Variable f
Variable g
Variable h
Controller status (when included)
Target data link status