Controller Ip Address Settings; Determining Ip Addresses - Omron NY532-5400 User Manual

4-2

Controller IP Address Settings

4-2-1

Determining IP Addresses

Use one of the following methods to set the IP address for the built-in EtherNet/IP port on the NY-series
Controller. The IP address for the internal port can be set only by using a user-specified address.
Setting a User-specified IP Address
If you need to change the default IP address of the built-in EtherNet/IP port or if you need to use the
built-in EtherNet/IP port with another EtherNet/IP node, set the IP address to the required value.
For an NX-series CPU Unit, you cannot set IP addresses that make two built-in EtherNet/IP ports
belong to the same network.
Automatically Obtaining the IP Address from the BOOTP Server
There are two methods to automatically obtain an IP address.
• Obtain the IP address from the BOOTP server each time the power is turned ON.
• Obtain the IP address from the BOOTP server once when the power is turned ON and then do not
allow it to change.
BOOTP server
BOOTP command
IP address
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
NY-series Controller
BOOTP client

4 Determining IP Addresses

Ethernet
NJ/NX-series Controller
4
4-5