Omron NY532-5400 User Manual page 105

 Port Forward
Setting
IP Forward
NAT
 Packet Filter
Setting
Packet Filter
Pass Frame
Specification
method
*4
IP address
Subnet mask
Protocol
Range specifica-
tion
Port A
Port B
*1 By default, only the reception of IP packets transmitted from a network to which the internal port belongs (on
the Windows side) is permitted.
*2 Specify the IP address by setting the items IP address and Subnet mask.
*3 This indicates a network to which the IP address for the internal port belongs. Unlike IP address specification,
you do not need to change this setting even if you change the IP address for the internal port after setting this.
*4 You need to set this item only if you set Specification method to IP address specification.
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
5 Sysmac Studio Settings for the Built-in EtherNet/IP Port
Specify whether to relay IP packets between the built-in Ether-
Net/IP port and the internal port on the Controller.
Specify whether to convert the source IP address to the IP
address for the built-in EtherNet/IP port if packets from Windows
are relayed via the internal port to a network on the built-in Ether-
Net/IP port side.
Specify whether to set conditions for the IP packets received by the
internal port.
Specify the conditions for the IP packets permitted to be received
by the internal port by setting the items shown below. You can set a
maximum of 32 conditions for the IP packets permitted to be
received.
This setting is valid only if you set Packet Filter to Use.
Select from the following the specification method for the IP pack-
ets permitted to be received.
• IP address specification
• any
*3
• Interface network
Set the IP address for which you permit reception.
*4 Set the subnet mask for which you permit reception.
Select any, tcp, udp, igmp, or icmp.
If you set Protocol to tcp or udp, specify whether to set a range of
port numbers for which you permit reception.
• Selected
Range specification is enabled. Specify a range by setting the
items Port A and Port B.
• No check
Range specification is disabled. Set an individual port number in
the item Port A.
Set the starting IP address of the range for which you permit recep-
tion.
Set the ending IP address of the range for which you permit recep-
tion. You need to set this only if you selected Range specification.
Description
Description
*2
Default
Use
Use
Default
*1
Use
---
Interface net-
work
5
None
None
any
No check
None
None
5-5