Snmp Settings Display - Omron NY532-5400 User Manual

5 Sysmac Studio Settings for the Built-in EtherNet/IP Port
5-4

SNMP Settings Display

 SNMP Service
Setting
SNMP service
*2
Port No.
Address
Location
Send a recognition trap
*1 If you specify to use the SNMP trap, you also have to set the recognition 1 and 2 as described below.
*2 The following ports are used by the system and cannot be set by the user: 25, 53, 68, 110, 2222, 2223, 2224,
9600, and 44818.
Additional Information
Refer to Section 12 SNMP Agent for details on the SNMP service.
5-8
Specify whether to use the SNMP monitor service.
If not using the SNMP monitor service is specified, an
SNMP manager cannot connect from an external
device.
Set the port number to use to connect to the SMTP
server that is used to connect from an SNMP man-
ager. This setting does not normally need to be
changed.
Set the communications device administrator name
and installation location as text information. You do not
necessarily have to input all items. This information is
read by the SNMP manager. (You can input up to 255
single-byte alphanumeric characters for each item.)
Set whether to send an authentication trap. If you
select Send a recognition trap and there is access
from an SNMP manager that is not set in Recognition
1 or Recognition 2, an authentication trap is sent to the
SNMP manager. If you select Send a recognition trap,
specify the SNMP trap settings on the SNMP Trap Tab
Page.
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
Description Default
Do not use.
*1
161
None
None
Do not use.