Omron NY532-5400 User Manual page 48

1 Introduction
6
Check operation.
• Check the built-in EtherNet/IP port indicators.
• Use the Sysmac Studio to check the communications status with the All Tag
Data Link Communications Status system-defined variable.
• Use the monitor function of the Network Configurator to confirm that the tag
data links are in normal operation.
 Using the CIP Message Communications Service
• CIP Communications Instructions
1
Execute CIP communications instructions in the user program.
2
Check operation.
• Use the Sysmac Studio to check the communications status with the end codes
of the instruction (Done, Error, and ErrorID).
 Using the Socket Services
1
Execute the socket service instructions in the user program.
2
Check operation.
• Use the Sysmac Studio to check the communications status with the end codes
of the instruction (Done, Error, and ErrorID).
 Using the FTP Server
1
Use the Sysmac Studio to set the initial settings of the EtherNet/IP
Function Module.
• Set the FTP settings (enabling FTP, login name, and password).
2
Connect to the FTP server in NY-series Controller from an FTP cli-
ent application.
• Input the FTP login name and password to log onto the built-in EtherNet/IP port.
• Check the event log to see if the FTP server started.
Precautions for Correct Use Precautions for Correct Use
To use the FTP server, you need to make the Virtual SD Memory Card settings in advance.
Refer to the NY-series Industrial Panel PC / Industrial Box PC Software User's Manual (Cat. No.
W558) for information on making the Virtual SD Memory Card settings.
1-22
↓
↓
↓
↓
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
1-3-2 Part Names and Func-
tions
Section 14 Checking Com-
munications Status of Net-
work and Troubleshooting
Section 8 CIP Message
Communications
1-3-2 Part Names and Func-
tions
Section 14 Checking Com-
munications Status of Net-
work and Troubleshooting
Section 9 Socket Service
Section 10 FTP Server