Omron NY532-5400 User Manual page 49

 Using the FTP Client
1
Execute the FTP client communications instructions in the user pro-
gram.
2
Check operation.
• Use the Sysmac Studio to check the communications status with the end codes
of the instruction (Done, Error, and ErrorID).
Precautions for Correct Use Precautions for Correct Use
To use the FTP client, you need to make the Virtual SD Memory Card settings in advance. Refer
to the NY-series Industrial Panel PC / Industrial Box PC Software User's Manual (Cat. No.
W558) for information on making the Virtual SD Memory Card settings.
 Using the SNMP Agent
1
Use the Sysmac Studio to set the initial settings of the EtherNet/IP
Function Module.
• Set the SNMP settings.
• Set the SNMP trap settings.
2
Check operation.
• Check the event log to see if the SNMP agent started.
 Using BOOTP
1
Use the Sysmac Studio to set the initial settings of the EtherNet/IP
Function Module.
• Set the BOOTP settings.
2
Check operation.
• Check the event log to see if BOOTP started.
• Check the Online system-defined variable.
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
↓
↓
↓
1 Introduction
Section 11 FTP Client
Section 12 SNMP Agent
Section 5 Sysmac Studio
Settings for the Built-in Eth-
erNet/IP Port
1-23
1