Omron NY532-5400 User Manual page 245

Attribute ID Parameter name
05 hex Media Counters
Alignment Errors
FCS Errors
Single Collisions
Multiple Collisions
SQE Test Errors
Deferred Transmissions
Late Collisions
Excessive Collisions
MAC Transmit Errors
Carrier Sense Errors
Frame Too Long
MAC Receive Errors
06 hex Interface Control
Control Bits
Forced Interface Speed
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
Description
Media counters for the communi-
cations port.
Number of frames received that
were not octets in length.
Number of frames received that
did not pass the FCS check.
Number of frames sent success-
fully with only one collision.
Number of frames sent success-
fully with two or more collisions.
Number of times a SQE test error
message was generated.
The number of frames for which
the first attempt to send was
delayed because the media was
busy.
The number of collisions detected
in packets that were sent after
512 bit times.
The number of frames that failed
to be sent because of excessive
collisions.
The number of frames that failed
to be sent due to an internal MAC
sublayer transmission error.
The number of times the carrier
sense condition was lost or the
number of times an assertion did
not occur when an attempt was
made to send the frame.
The number of frames received
that exceeded the maximum
allowed frame size.
The number of frames that could
not be received through the inter-
face due to an internal MAC sub-
layer reception error.
Control settings for the interface.
Auto Nego for Ethernet communi-
cations that specifies full duplex.
Gives the set value of the Ether-
net baud rate.
8 CIP Message Communications
Read/write data
Attribute
Data
type
Read Struct ---
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
UDINT Reads the current value.
Write Struct ---
WORD Refer to (2) Control Bit Details,
below.
UINT Reads the set value.
Value
8
8-49