Specifications; General Specifications - Mitsubishi Electric GT1695M-XTBD User Manual

3.

SPECIFICATIONS

3.1 General Specifications

Item
Display section 0 to 50°C
Operating
ambient
Other than the
*1
temperature
display section
Storage ambient temperature
Operating ambient humidity
Storage ambient humidity
Vibration resistance
Shock resistance
Operating atmosphere
*2
Operating altitude
Installation location
*3
Overvoltage category
*4
Pollution degree
Cooling method
Grounding
*1 When mounting a multimedia unit (GT16M-MMR), MELSECNET/H communication unit (GT15-J71LP23-25,
GT15-J71BR13), or CC-Link communication unit (GT15-J61BT13), the operating ambient temperature must be
reduced 5 °C against the maximum values described in general specifications.
*2 Do not use or store the GOT under pressure higher than the atmospheric pressure of altitude 0m (0ft.). Failure to
observe this instruction may cause a malfunction.
*3 This indicates the section of the power supply to which the equipment is assumed to be connected between the
public electrical power distribution network and the machinery within the premises.
Category II applies to equipment for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the raged voltage of 300 V is 2500 V.
*4 This index indicates the degree to which conductive material is generated in the environment where the
equipment is used.
In pollution degree 2, only non-conductive pollution occurs but temporary conductivity may be produced due to
condensation.
0 to 55°C
-20 to 60°C
10 to 90% RH, non-condensing
10 to 90% RH, non-condensing
Compliant Under
with JIS intermittent
B3502 and vibration
IEC61131-2
Under
continuous
vibration
Compliant with JIS B3502, IEC 61131-2 (147 m/s
directions)
No corrosive gas
2000 m (6562 ft) max.
Inside control panel
II or less
2 or less
Self-cooling
Grounding with a resistance of 100
Specifications
Frequency Acceleration
amplitude
5 to 9Hz -
2
9 to 150Hz
9.8m/s
5 to 9Hz -
2
9 to 150Hz
4.9m/s
2
, 3 times each in X, Y and Z
or less
3.1 General Specifications
Half-
Sweep count
3.5mm
- 10 times each
in X, Y and Z
1.75mm
directions
-
3
- 1
1
2
3
4
5
6
7
8