Mitsubishi Electric GT1695M-XTBD User Manual page 123

4 After the installation, tighten a fixing screw within the specified torque range (0.25 to 0.35N·m).
5 After the installation of option function board, attach the extension unit cover.
(For installation of extension unit, install the extension unit.)
4 Battery
Replace battery periodically by referring to 3.4 Battery Specifications.
1 Keep the GOT power supply on for 10 minutes or more, and turn it off. (Executes step
within 5 minutes of powering the GOT power supply off.)
2 Open the battery holder on the GOT rear face.
3 Remove the old battery from the GOT and disconnect the connector.
4 Connect the new battery to the connector.
5 Install the battery and close the battery holder.
6 Turn the GOT power supply on.
7 Check if the battery condition is normal within the utility.
Refer to the following for the details of battery status display.
9.1.1 Time setting
1. Precautions after battery replacement
Make sure to turn on the GOT power supply once upon completion of battery
replacement.
Failure to do so may decrease the battery life.
7.3 Option
7.3.2 Installation procedure
1
2
3
to
4
5
6
7
8
7
- 40