When installing an extension unit on the unit, refer to the following.
When not installing an extension unit on the outer layer, cover the top of mounting screws (4
places) with accessory stickers in order to avoid receiving static electricity.
Keep the connector cover fixed.
Keep the sticker stuck as it is.
This section describes how to install printer on GOT.
A printer unit and another extension unit can be installed on a GOT together.
Refer to the following item after implementing the steps described in this section.
One printer unit can be installed at either 1st to 3rd stage of the exteded interface.
(1) Cable connection
Connect the dedicated printer connection cable to the printer unit.
Attach the accessory connector holder to the dedicated printer connection cable and tighten the
screw of connector holder with tightening torque of 0.36 to 0.48N·m.
7.2 Option Unit
7.2.2 Installing procedure
7.1.3 Installing multiple extension units in layers