USB environmental protection cover
The USB environment cover protects the USB interface on the front face of GOT from dust, water, and
The GOT is installed with the USB environment cover at factory shipment.
Replace when damage and deterioration are caused.
Note that this does not guarantee all users' operation environment.
In addition, the GOT may not be available for use in the environment where oil or chemicals are splashed over for
a long period or where oil mist is filled.
Get up the hinge of the USB environmental protection cover.
Put the provided fixing screw through the hinge hole, and then fit the screw in the cover
installation hole on the GOT.
Tighten the screw with a torque of 0.36 to 0.48N•m.
Fitting the hinge projections in the GOT guiding holes makes the cover installation work easier.
When the USB interface is not used, fix the cover by pushing the
mark on the latch firmly.
7.3.2 Installation procedure