Debug Setting; Q/Qna Ladder Monitor Setting - Mitsubishi Electric GT1695M-XTBD User Manual

11.2 Debug Setting

11.2.1 Q/QnA ladder monitor setting

Storage locations and others for data to be used for the ladder monitor function can be set.
Saving the ladder data cuts out the need for reading the ladder data from PLC CPU at the next GOT start-up,
enabling to start the ladder monitoring earlier.
Refer to the following manual for details of the ladder monitoring function.
Function
Select the ladder data storage location of the Q/
Data save location
QnA ladder monitor.
Whether to automatically read sequence program
Automatic
when the ladder monitor starts from a touch switch
program read
or Advanced Alarm Display can be selected.
If both Common comment and Each program
comment are set for the same device in a
Priority comment
sequence program, select either of the comments
to be displayed in the ladder monitor.
Select if monitoring local devices are executed or
not when monitoring devices with the ladder
Local device
monitor.
monitor
(Applicable to only the MELSEC-Q series ladder
monitor)
Drive for device Select the drive to be used for reading comment
comment data for the ladder monitor.
11
11.2 Debug Setting
- 3
11.2.1 Q/QnA ladder monitor setting
GOT1000 Series Extended/Option Functions Manual
Description
Ladder data to be saved
(a) The ladder data to be saved is used by the GOT to execute ladder
monitoring.
The ladder data can be saved in the CF card with this function, however it
cannot be copied in the PC to be referred/edited with GX Developer, etc.
The name of the ladder data to be stored can be checked with the project
information.
For how to check the name of ladder data, refer to the following.
13.3.2
(b) The ladder data saved in the built-in flash memory and CF card or USB
memory (file name: CIRDAT) can be deleted by selecting [Project
information] in [OS/project information] of [Data control].
13.3.2
C: Flash Memory/B: Memory card/A: Built-in CF Card/Not store
<Default: C: Flash Memory>
YES/NO
<Default: YES>
Common comment/Each program comment
<Default: Common comment>
YES/NO
<Default: NO>
A:Built-in CF card/B:Memory card
<Default: A:Built-in CF card>
Display operation of project information
Operation of project information
Setting range