Mitsubishi Electric GT1695M-XTBD User Manual page 420

2 For GT16-80SLTT
1 Turn off the GOT.
2 Disconnect the power supply cable and the communication cable. Remove the GOT from the control
panel.
3 Remove the right extension unit cover of the GOT.
Remove an extension unit, including a bus connection unit, if it is mounted.
4 Remove eight fixing screws on the GOT rear face with a screwdriver.
5 Remove the cable connector of the backlight from the connector of the GOT board.
(Expanded figure of part A in 4))
6 When replacing the GT16-80SLTT, remove the cables from the cable holder.
7 Press the backlight fixing latch (black) with your fingers, and pull out the backlight to the left.
When pulling out the backlight, press the packing with your fingers so that the backlight does not hit the
packing.
15
15.6 Backlight Replacement
- 8
15.6.2 Replacement procedure of backlight
Top
Bottom
A
Top
Cable holder
Latch