9.2 Display Settings
9.2.1 Display setting functions
(4) Display control by human sensor
The human sensor is a function that releases the GOT from the screen saving
mode without the necessity to touch the GOT.
This function releases the GOT from the screen saving mode when the operator
has come closer to the GOT.
"System Signal 2-1.b5"
Screen saving mode released
When there is no operator around the GOT for the time set as "Sensor OFF delay", the "Human
Sensor Detection Signal" turns OFF.
When the time set as the "Screen save time" elapses after the "Human Sensor Detection Signal"
turns OFF, the GOT enters the screen saving mode.
Refer to the following manual for the Human Sensor Detection Signal (System
GT Designer2 Version
(3.6 Setting System Information)
(5) When setting the human sensor to invalid
Even if setting the human sensor to invalid by the utility, the Human Sensor
Detection Signal (System Signal 2-1.b5) turns ON when the human sensor
detects human movement.
Unintended operation may result, therefore, if controlling the Forced Screen Saver
Enable Signal (System Signal 1-1.b1) and Human Sensor Detection Signal
associating them with each other by a sequence program, etc.
When setting the human sensor to invalid, review the related sequence program,
Go away Approach
"Screen save time"
Screen Design Manual