Install the video/RGB unit on the extension interface of the GOT rear face.
(When the extension unit is installed in GOT, remove the installed extension unit. And, do not
touch the board in the GOT when install the video/RGB unit.)
After the installation, tighten the mounting screws (4 places) in the specified torque range (0.36
Tighten the extend interface relay board installed by the step
range (0.36 to 0.48N·m). (2 places)
Removing the video/RGB unit
Before removing the unit, unscrew the extend interface relay board fixing screws.
within the specified torque
7.2 Option Unit
7.2.2 Installing procedure