This section describes how to install a communication unit on a GOT.
A communication unit can also be installed together with another extension unit.
When installing a communication unit together with some other extension unit, after executing the procedure
in this section, refer to the following.
Bus connection unit
(1) GT15-QBUS, GT15-ABUS
Power OFF the GOT.
Remove one extension unit cover of the GOT.
Fit the communication unit in the GOT case.
Fasten the communication unit by tightening its mounting screws (2 places) with tightening
torque of 0.36 to 0.48 N·m.
7.1 Communication Unit
7.1.2 Installing procedure
7.1.3 Installing multiple extension units in layers