Mitsubishi Electric GT1695M-XTBD User Manual page 93

3 MELSECNET/H communication unit, CC-Link IE controller network communication
unit, CC-Link communication unit (GT15-J61BT13)
(1) Unit installation
1 Power off the GOT.
2 Remove the two extension unit covers of the GOT rear face.
3 Install the extend interface relay board on the Extend interface 2 side of the GOT.
After the installation, detach the connector cover from the extend interface relay board.
4 Install the communication unit on the extension interface of the GOT rear face.
(When the extension unit is installed in GOT, remove the installed extension unit. And, do not
touch the board in the GOT when install the communication unit.)
Remove the connector cover
7.1 Communication Unit
7.1.2 Installing procedure
1
2
3
4
5
6
7
8
7
- 10