Mitsubishi Electric GT1695M-XTBD User Manual page 109

5 Sound output unit
The sound output unit can be installed on the GOT with other extension units.
For installing the sound output unit with other extension units, refer to the following after implementing
the steps described in this section.
One sound output unit can be installed in any position (1st to 3rd stage) of the extension interface.
(1) Cable connection
1 Connect a cable of an external speaker to the sound output unit.
2 Attach the cable clamp to the unit.
Be sure to attach the cable clamp to section A as shown in the following figure with its band
positioned outside until it clicks.
Put the band of the cable clamp through the hole of the cable clamp in the direction of the arrow.
(The RST-1NB manufactured by TAKEUCHI INDUSTRY CO., LTD. is applicable as the cable
clamp.)
Put the cable of the external speaker through the looped cable clamp band, and pull the band for
fixing the cable.
Cable of
external
speaker
A
Cable clamp
7.2 Option Unit
7.2.2 Installing procedure
1
2
3
4
5
6
7
8
7
- 26