Preparation; Mmi Commands And Mts Modes Of Operation - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Preparation

Preparation
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Please carefully go through preparation section before proceeding with configuration and testing.
Process 6-1 Preparation Procedures

"MMI Commands and MTS Modes of Operation"

1
Interface Commands.
"Test Equipment"
2
Radio Verification.
"Service Terminal Setup"
3
MMI Commands and MTS Modes of Operation
Service technicians can communicate with the MTS through the use of MMI commands and a service
terminal (laptop). MMI commands provide testing capabilities with access to alarm log files and
various diagnostic tests. MMI commands also provide a means to configure the site controller and
base radio(s) for intended operation, and to enable various system tests.
The testing of the MTS by using the MMI can be done in Test Application Mode or with sets
of commands available for Site Controller and Base Radio.
A selected number of MMI commands are used in the procedures within this chapter. The
complete set of MMI commands, including both Site Controller and base radio commands,
is defined in the "MTS Interface Commands" booklet.
6-2
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
- Identifies all recommended test equipment for the Site Controller and Base
- Describes how to connect a service terminal.
You must be familiar with Man-Machine Interface (MMI) commands and their
usage prior to performing procedures in this chapter. Improperly applying
MMI commands can cause damage to the equipment.
The "MTS Interface Commands" booklet serves as an introduction and reference for
using the software commands. If you are not totally familiar with using the commands,
read the "MTS Interface Commands" booklet before proceeding.
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
- briefly describes the usage of Man Machine
Chapter 6: Configuration and Testing
■ ■ ■ ■
■
■
6802800U74-N September 2009