Format For Log Masks - Siemens SINUMERIK 840C Installation Instructions Manual

4 MMC Area Diagnosis
4.4.2 Configuration file CONFIG
BT_Name
PROTLEN1
PROTLEN2
FLUSHLEN1
FLUSHLEN2

4.4.2.3 Format for log masks

Note
1) Up to SW2
4–28
More user manuals on
FlexOS name of the operator panel interface.
For operation without the operator panel enter "" only. The default setting is
"SER" (upper case mandatory).
This defines the number of messages that are entered in alarm log 1.
This defines the number of messages that are entered in alarm log 2.
Maximum number of messages buffered for the alarm log (lost on voltage
failure).
Maximum number of messages buffered for the service log (lost on voltage
failure).
As from SW3, the alarms are configured in the 'MELDATTR' and 'MELDTEXT'
files. For configuring notes, please refere to Interface, Part 1.
You can define which messages are to be entered in the log by specifying the
attributes of these messages and the limitations which apply to them. Each mes-
sage attribute is abbreviated to its initial letter (Number, Klasse = class), Type,
Priority). The limitations are specified using the characters '<', '>', '=' and '–'.
Examples:
N > 1000
P < 5
P = 0
N50 – 100
A 'PROTMASK' line can comprise several such limitations, which are then inter-
preted as logically ANDed. If several 'PROTMASK' lines (up to 5) are specified
for one log they are logically ORed.
The values of type and class of a message are coded as follows:
Type of alarm
Power-on alarm
Reset larm
Cancel alarm
PLC alarm
PLC message
NCK comment
NCK
System / master control
Services
Diagnosis
Programming
User (OEM)
Table 4.1 Coding of message types and classes
ManualsBase.com
Messages with a number greater than 1000 are logged
Messages with a priority less than 5 are logged
Messages with a priority of 0 are logged
Messages with a priority between 50 and 100 are logged.
Class

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
Coding
0
1
2
3
4
1)
5
Coding
0
1
2
3
4
6
SINUMERIK 840C (IA)