Siemens SINUMERIK 840C Installation Instructions Manual page 387

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.9 MDs for parameter set switchover
3032*-
3060*
Default value
1
3064*-
3092*
Default value
1
This machine data is used to define the speed ratio of a gear box for all parameter sets, see
functional description of ""Ratio" parameter group".
3096*-
3124*
Default value
0
3128*-
3156*
Default value
0
These MDs are used to correct gear-stage-related offsets between the zero mark and
reference position, see functional description of ""Ratio" parameter group".
3160*-
3184*
Default value
0
For axes only:
To compensate for the backlash in different gear stages.
3188*-
3212*
Default value
0
These MD have the same meaning as MD 1292*, see also "Functional Descriptions:
Parameter set switchover".
_______
1) As from SW 4.4
2) As from SW 4
6–202
More user manuals on
Number of teeth motor
Lower input limit
1
Number of teeth spindle
Lower input limit
1
Zero mark correction +
Lower input limit
- 999 999
16 000 (as from SW 4.4)
Zero mark correction -
Lower input limit
- 999 999
16 000 (as from SW 4.4)
Backlash comp. 1st measuring system
Lower input limit
- 16 000
Motor control equilibration 2nd - 8th par. set
Lower input limit
-70
-700 (as from SW 4.4)
ManualsBase.com
2)
1st par. set to 8th par. set
Upper input limit
999 999
99 999 999 (as from SW 4.4)
2)
1st par. set to 8th par. set
Upper input limit
999 999
99 999 999 (as from SW 4.4)
2)
1st par. set to 8th par. set
Upper input limit
999 999
16 000 (as from SW 4.4)
2)
1st par. set to 8th par. set
Upper input limit
999 999
16 000 (as from SW 4.4)
2)
2nd par. set to
8th par. set
Upper input limit
16 000
as from SW 4
Upper input limit
70
-700 (as from SW 4.4)
©
Siemens AG 1992 All Rights Reserved
09.95
Active on
Power On
Units
–
Active on
Power On
Units
–
Active on
NC Stop
Units
units (MS)
Active on
NC Stop
Units
units (MS)
Active on
NC Stop
Units
units (MS)
Active on
NC Stop
Units
0.1 % of the power
section current
6FC5197- AA50
SINUMERIK 840C (IA)