Siemens SINUMERIK 840C Installation Instructions Manual page 53

Hide thumbs Also See for SINUMERIK 840C:

Table of Contents

Installation

Key on the operator panel

1) The keyboard must be connected to the interface on the MMC-CPU.

SINUMERIK 840C (IA)

More user manuals on

When the PG software is selected, the 1st serial interface is disabled. It is only

enabled again when the PG mode is terminated.

With the PG software, it is possible to select other files as

well (not S5 files) to delete or copy them etc. with the func-

tion: object\DOS file\. The user is responsible for using this

function. System files can be deleted too.

Operation and application of the SIMATIC software STEP

5/MT level 6 is described in the relevant manual.

The function is supplied on tape and is installed in the BACKUP menu (see Sec-

tion BACKUP).

Starting from the DIAGNOSIS area, the function can be selected using softkey

PG function.

When operating the PG functions via the operator panel or MF2 keyboard, please

note the following changes in the key functions.

ManualsBase.com

Key on the MF2 keyboard

3 PLC Installation

3.2 PG function via MMC

Equivalent key/function on the

programming device

F8 (Cancel, ESC)

Simodrive 611-d