Siemens SINUMERIK 840C Installation Instructions Manual page 43

2 General Reset and Standard Start-Up
2.8 Standard installation short version (up to SW 2)
LOCK
PASSWORD
2-12
More user manuals on
When the softkeys, DIAGNOSIS, NC DIAGNOSIS, NC START-UP and ENTER
PASSWORD have been pressed, the following display appears:
MACHINE PARAMETER PROGRAMM.
JOG
NC alarms
Enter password
NC
MA. DAT
Fig. 2.3
The password for the NCK area is set in machine data 11. The default value 0
corresponds to password
Any other value defined in machine data 11 must have four digits.
The value is accepted with the INPUT key and the text "ENTER PASSWORD"
disappears.
The password is reset with the "Lock password" softkey.
If the password has not been set correctly, the message "Password incorrect" ap-
pears.
ManualsBase.com
PROGRAM RESET
PLC CYCLE ENTER
MA. DAT. MA. DAT. PASSWORD
+ +

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SERVICES DIAGNOSIS
16:38
M. No. :1
Chann :1
****
LOCK GENERAL
PASSWORD RESET MODE
+ .
SINUMERIK 840C (IA)
09.95