General Reset (Up To Sw 2) - Siemens SINUMERIK 840C Installation Instructions Manual

09.95
2.9
DEL./LOAD
MACH. DATA
DELETE
NC-MD
LOAD NC-MD
T VERSION
LOAD
DELETE
PLC-MD
LOAD
PLC-MD
Note

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
More user manuals on

General reset (up to SW 2)

MACHINE PARAMETER PROGRAMM.
JOG
Installation mode general reset
Del/load
MD
Fig. 2.4
The start-up sequence is obligatory since the NC and PLC machine data must
have been entered before the user memory is formatted and the part program
memory is deleted.
"DEL./LOAD MACH. DATA": The delete/load screenform is displayed.
"DELETE NC-MD": NC-MD are deleted and formatted.
or
LOAD NC-MD
M VERSION
If files exist on hard disk in the DIAGNOSIS, NC DATA MANAGEMENT, PC
DATA MANAGEMENT areas, softkey "LOAD" can be used to load these files from
the hard disk to the NCK-CPU.
"DELETE PLC-MD": PLC-MD are deleted and formatted.
"LOAD PLC-MD": The default PLC-MDs are loaded.
PLC-MDs are not transferred to the PLC until the general reset mode is exited.
For selecting data management, press the area switchover key, "DIAGNOSIS"
and "SHIFT" + "RECALL" in the General reset selection form.
ManualsBase.com
PROGRAM RESET
Delete machine data, load standard values
Initialize NC memory/user data, part program
Initial clear PLC memory/load basic program
Display NC alarms
Conclude installation, return to normal operation,
disable password (switchkey on central service board
module to 0!)
Initial Initial clear
memory PLC
"NC-MD LOAD T VERSION" or "NC-MD LOAD M VERSION":
Standard MD for T or M version are loaded.
2 General Reset and Standard Start-Up
2.9 General reset (up to SW 2)
SERVICES DIAGNOSIS
16:38
M. No. :1
Chann :1
Display
NC alarms
End
start-up
2-13