Standard Installation And Start-Up As Flowchart (As From Sw 3) - Siemens SINUMERIK 840C Installation Instructions Manual

2 General Reset and Standard Start-Up

2.2 Standard installation and start-up as flowchart (as from SW 3)

2.2
2-2
More user manuals on
Standard installation and start-up as flowchart (as from SW 3)
Default values can be used for data in general reset mode during initial installation
or after a loss of data caused by, for example, removal of a module, hardware
defect of a module or empty back-up battery in the case of power failure.
Yes
Start-up switch on CSB
in position "Start-up"
(1)
Switch on
General reset mode
refer to General Reset
Section
Softkey time/date
Set time and date
Load MD in MDD
Configure memory
(as from SW 4)
Start-up
control
END
ManualsBase.com
START
MMC-CPU
supplied with system
No
software

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
Connect
Valitek streamer
Switch on
Booting performed in
Backup menu
Load system software
from magnetic tape,
see Backup Section 4
Switch off
SINUMERIK 840C (IA)
09.95
08.96