Siemens SINUMERIK 840C Installation Instructions Manual page 610

8 PLC Machine Data (PLC MD)
8.5 PLC MD for the operating system (system bits)
PLC MD
DB63
DW No.
6035
DR 17
Default value:
K = 0, 4, 8, 12, ... 116 (1st to 30th axis)
Bit = 0
Bit = 1
Notes:
1) The bit applies to all axes.
2) If the identical bit is also set for operational messages (PLC MD 6043), the PLC goes into
the Stop loop.
Sample application:
DB 32 D 3.3
PLC MD 6035.1=
See PLC Installation Section.
PLC MD
DB63
DW No.
6036
DL 18
6037
DR 18
6038
DL 19
6039
DR 19
Default value:
Bit = 0
Bit = 1
Note:
If the identical bit is also set for operational messages (PLC MD 6044-6047), the PLC goes
into the Stop loop.
Sample application:
DB 58 D 3.10
PLC MD 6039.4 =
8–18
More user manuals on
7 6 5
All bits default to 0
The system software does not evaluate the bits in the corresponding interface
byte for error messages.
The system software evaluates the bits in the corresponding interface byte for
error messages.
1 signal error message 8211;
1
7 6 5
DR 4 DL 4 DR 3
DR 8 DL 8 DR 7
DR 12 DL 12 DR 11
DL 16 DR 15
All bits default to 0
The system software does not evaluate the bits in the corresponding interface
byte for error messages.
The system software evaluates the bits in the corresponding interface byte for
error messages.
1 signal error message 9034;
1
ManualsBase.com
Bit No.
4 3 2
Alarm DB 32
Bit No.
4 3 2
Alarm DB 58
DL 3 DR 2 DL 2
Alarm DB 58
DL 7 DR 6 DL 6
Alarm DB 58
DL 11 DR 10 DL 10
Alarm DB 58
DL 15 DR 14 DL 14
© Siemens AG 1992 All Rights Reserved
09.95
1 0
DR k+3 DL k+3
1 0
DR 1 DL 1
DR 5 DL 5
DR 9 DL 9
DR 13 DL 13
6FC5197- AA50
SINUMERIK 840C (IA)