Pc Data - Siemens SINUMERIK 840C Installation Instructions Manual

08.96 09.95
4.4
Overview
JOB LIST
WOP FILES
MMC directories and files
Fig. 4.10
Note
General notes
\List_module
Introduction
1) As from SW 3 also SIMULATION, as from SW 4 simulation is stored in the PROGRAMMING area.

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
More user manuals on

PC data

All data not documented in the following sections must not
be changed.
\LIST MODULE \WOP
\MESS.
\LANGUAGES
ATTR.
MELDTEXT
BEDCONF
NECOLLI
MELDINFO
POCOLLI
POCOCLUT
ANWMTEXT
NECOCLUT
POMOCLUT
\LIST_MODULE = directory, MELDTEXT = file
Configuration of the MDD using the list module is described in Section Machine
data dialog (MDD SW 3 and higher)
The user interface of the 840C control is divided into MACHINE, PARAMETERS,
PROGRAMMING, SERVICES, and DIAGNOSIS function areas.
You can set up the operator system using a configuration file and a series of
other files. The files initially contain default values, but you can change these with
the ASCII editor in the MMC area DIAGNOSIS (the ASCII editor is described in
the Operator's Guide).
The file system is made up of two branches, SIEMENS and USER. SIEMENS
contains the initial system settings which cannot be changed.
If the control does not find any data in the USER branch, it obtains its data from
the SIEMENS branch.
ManualsBase.com
\MASTER
\OPERATION
CONTROL
\BASIC
\CONFIG. \USER
SETTINGS
NEMOCLUT
4 MMC Area Diagnosis
4.4 PC data
\
Alt
\FUNCTION AREAS ... \DIAGNOSIS
BEDCONF
NEMOCLUT
NECOCLUT
POMOCLUT
POCOCLUT
1)
4–21