Cycles Machine Data - Siemens SINUMERIK 840C Installation Instructions Manual

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.12.1 NC setting data (NC SD)
Setting data for the additive protection zone adaptation (as from SW 6)
The values for the coordination of the dynamic protection zone adaptation are to be entered in
the following setting data bits:
SD
No.
800*
Protection zone enlargement in X+ direction
804*
Protection zone enlargement in Y+ direction
808*
Protection zone enlargement in Z+ direction
812*
Protection zone enlargement in X- direction
816*
Protection zone enlargement in Y- direction
820*
Protection zone enlargement in Z- direction
These setting data are activated by MD 3876* bit 1.
6.13

Cycles machine data

The cycles machine data are active only when you use the measuring cycles from Version 20.
For a detailed description of the cycles machine data please refer to the
6–230
More user manuals on
Description
Start-up Guide
Measuring Cycles, Versions 20 and 30
END OF SECTION
ManualsBase.com
Default Maximum
value input value
0 9999 9999
0 9999 9999
0 9999 9999
0 9999 9999
0 9999 9999
0 9999 9999
©
Siemens AG 1992 All Rights Reserved
01.99
Reference
Input unit
system
IS –
IS –
IS –
IS –
IS –
IS –
6FC5197- AA50
SINUMERIK 840C (IA)