Selection Of Measured Signal - Siemens SINUMERIK 840C Installation Instructions Manual

9 Drive Servo Start-Up Application (as from SW 3)

9.6.1 Selection of measured signal

9.6.1
Selection
meas. signal
Explanation
SERVO signals for
axes/spindles
SERVO signals for axes Contour deviation
SERVO signals for
spindles
Special SERVO signals Part actual value 1st MS
611D signals in position Current actual value
controller cycle
NCK signals
(as from SW 5)
9–66
More user manuals on
Selection of measured signal
You can select lists containing a selection of signals with this vertical softkey (see
Fig. 9.35).
Signals are selected or deselected with the cursor hardkeys and softkeys ok and
Abort. The page-up and page-down hardkeys can be used to scroll in this list.
Following error
Absolute setpoint
Absolute actual value
Speed setpoint (0.01 %)
Part actual value (active)
Part setpoint
Synchronism error
Abs. compensation value
Speed setpoint (present)
Speed setpoint (RFG output)
Speed actual value
Part actual value 2nd MS
Following error (IPO cycle)
Absolute value modulo
Part setpoint (FIPO input)
Absolute position setpoint (PC)
Part setpoint (FIPO output)
Part compensation value FIPO output
Part compensation value FIPO input
Leading axis total actual value link
Leading axis total all leading axes
Leading axis total active
Angular offset (mech. coupling)
Position setpoint (PC cycle)
Absolute actual value (PC cycle)
Quadrant error
Quadrant error plane
Torque compensation controller output (SW 5)
Setpoint torque compensation control (SW 5)
Power
Torque
Torque (delta)
Speed actual value
Capacity utilization in %
Axial feedrate
Path feedrate
Distance-to-go path
Distance-to-go axis
Number of predecoded blocks
Capacity utilization
Set position before transformation
Path feedrate before transformation
IKA input A
IKA input B
IKA output
ManualsBase.com

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
SINUMERIK 840C (IA)