Siemens SINUMERIK 840C Installation Instructions Manual page 198

12.93
13
Normally, each tool offset has up to ten permanently allocated TO parameters. When required,
the user can upgrade the number of parameters to 32, and must allocate the added param-
eters (10 to 32) using the configuring terminal. The greater the number of TO parameters
allocated to a tool offset, the lower the number of tool offsets available to the user, as the
memory space available for tool offsets is limited.
Parameter
Note carefully:
Modifications do not take effect until user memory has been formatted.
User memory is formatted in "Overall Reset" mode with either the "Format User Data" or the
"Format TO Data" softkey. For inform. on selecting "Overall Reset" mode, refer to Section
General Reset.
Number of D memories=
For SW 4 and higher see functional description "Flexible Memory Configuration".
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Number of TO parameters
Default value Lower input limit
10
TO
10 204
11 186
12 170
13 157
14 146
15 136
16 128
17 120
18 113
19 107
20 102
21 97
22 93
23 89
24 85
25 81
26 78
27 75
28 73
29 70
30 68
31 66
32 64
Memory configuration [BYTES]
Number of TO parameters *4
ManualsBase.com
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.1.4 Breakdown of NC MDs/drive machine data
Upper input limit
10 32
Comments
409 Initial setting
372
341
315
292
273
256
240
227
215
204
195
186
178
170
163
157
151
146
141
136
132
128
(16 K tool memory)
Basic version with 8 K tool memory
6FC5197- AA50
Active
see below
Units
–
6–13