Siemens SINUMERIK 840C Installation Instructions Manual page 611

09.95
PLC MD
DB63
DW No.
6040
DL 20
6041
DR 20
Default value:
Bit = 0
Bit = 1
Notes:
1) The bit applies to all NC channels.
2) If the same bit is also set for error messages (PLC MD 6032, 6033), the PLC goes into the
Stop loop.
Sample application:
DB 10 D 6.8
PLC MD 6040.0=
See PLC Installation Section.
© Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
7 6
DR 9 DL 9
All bits default to 0
The system software does not evaluate the bits in the corresponding interface
byte for operational messages.
The system software evaluates the bits in the corresponding interface byte for
operational messages.
1 signal operational message 6000;
1
ManualsBase.com
8.5 PLC MD for the operating system (system bits)
Bit No.
5 4 3
Signal channel DB
DR 8 DL 8 DR7
Signal channel DB
DR 11
6FC5197- AA50
8 PLC Machine Data (PLC MD)
2 1 0
DL 7 DR 6 DL 6
DL 11 DR 10 DL 10
8–19