Siemens SINUMERIK 840C Installation Instructions Manual page 413

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.12.1 NC setting data (NC SD)
Axial bits
SD MD
560*
Bit 2 The scale factor (G51) is active during machining.
Bit 1 Override switch for rapid traverse no longer active in the axis in question.
Bit 0 Override switch for feedrate no longer active in the axis in question.
SD
564*
Evaluation of handwheel pulses (applies to both handwheels) per axis
Bit 0=1
Bit 1=1
Bit 2=1
Bit 3=1
Bit 4=1
Spindle converter setting data
SD
600*
to
625*
The setting data are stored as follows in binary format.
SD 600*
SD 604*
SD 608*
SD 612* spindle conversion list on/off (1=on, 0=off)
These setting data can be altered via @311, @312, @411, @412 / PLC / RS 232 C (V24).
The spindle converter only operates in the automatic, teach-in and MDA modes but not with
overstore.
The automatic basic display does not show that the spindle converter is active.
Note:
See Functional Description for detailed description.
6–228
More user manuals on
7 6 5
7 6 5
1 increment per handwheel pulse (display resolution)
10 increments per handwheel pulse (display resolution)
100
1000
10000
7 6 5
1st progr. spindle channel-specific
2nd progr. spindle channel-specific
3rd progr. spindle channel-specific
ManualsBase.com
Bit No.
4 3 2
Scale factor
active on
machine
Bit No.
4 3 2
Increments per handwheel pulse
10000 1000 100
"..."
"..."
"..."
Bit No.
4 3 2
Spindle converter
SD 602* 1st real spindle channel-specific
SD 606* 2nd real spindle channel-specific
SD 610* 3rd real spindle channel-specific
©
Siemens AG 1992 All Rights Reserved
07.97
1 0
Rapid Feedrate
override not override not
active active
1 0
10 1
1 0
6FC5197- AA50
SINUMERIK 840C (IA)