Keywords - Siemens SINUMERIK 840C Installation Instructions Manual

4 MMC Area Diagnosis
4.4.2 Configuration file CONFIG

4.4.2.1 Keywords

1) Up to SW 2 only
2) SW 4.4 and higher
3) SW 5 and higher
4–26
More user manuals on
Keywords are words reserved by the system.
The following keywords exist:
S
LANGUAGE
S
LANGUAGE1
S
LANGUAGE2
S
LANGUAGE3
S
LANGUAGE4
S
BT_NAME
S
BT_PARAM
S
PROTLEN1
S
PROTLEN2
S
FLUSHLEN1
S
FLUSHLEN 2
S
FLUSHTIME
S
PROTMASK1
S
PROTMASK2
S
PRIO_PO
S
PRIO_RE
S
PRIO_CA
S
PRIO_PA
S
PRIO_PM
S
PRIO_KO
S
SYSFONT
S
TFORMAT
ManualsBase.com
Language set for NCK and MMC
3)
Language set for WOP
Language set for simulation
Language set for PG function
3)
Language set for user
FlexOS name of the operator panel interface
Name ""; operation without operator panel
Size of the alarm log in number of messages
Size of the service log in number of messages
Maximum number of messages buffered for the alarm log
Maximum number of messages buffered for the service log
Maximum buffering time for messages in milliseconds
Type of messages to be entered in the alarm log
Type of messages to be entered in the service log
Display priority of NCK alarms with alarm type "power on"
Display priority of NCK alarms with alarm type "reset"
Display priority of NCK alarms with alarm type "cancel"
Display priority of PLC alarms
Display priority of PLC messages
Display priority of NCK comments
Defines the character set in the configuration file of the
2)
master control
Format in which the times are to be written to the log

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
3)
3)
1)
1)
1)
1)
1)
SINUMERIK 840C (IA)
09.95
1)
1)