Softkeys - Siemens SINUMERIK 840C Installation Instructions Manual

9 Drive Servo Start-Up Application (as from SW 3)
9.1.1 Selection of/menu trees drive servo start-up application
D Menu tree: Spindle start-up function
1)
Measure-
ment
Measure-
ment
Measure-
ment
Measure-
ment
9.1.2
Start
Stop
1) as from SW 4
9–6
More user manuals on
Start-up
fct. spindle
Meas.
Contr.para
paras.
drive
Meas. Contr.para
paras. drive
Meas. Contr.para
paras. drive
Signal- Contr.para
paras. drive

Softkeys

This softkey enables the measurement or the DAC output. In order to start a
measurement with traversing operation, the traverse enabling commands set by
means of toggle field from the PLC/NC must be available. This operator action is
acknowledged by an appropriate message.
The measurement or the DAC output is enabled by selecting the Start softkey,
but can be disabled again with the Stop softkey. The function is aborted if the
Recall hardkey is pressed without a preceding NC start command.
This softkey aborts the measurement, DAC output or traversing operation
(function generator, QEC learning process) which is in progress.
ManualsBase.com
1)
Current Speed Position
contr. loop
contr. loop contr. loop
Display File
functions
Display File
functions
Contr.para Display File
NC functions
Contr.para File
NC functions

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
Function
generator
SINUMERIK 840C (IA)
09.95