2Nd Level: Configuring The Individual Machine Data Areas (As From Sw 3) - Siemens SINUMERIK 840C Installation Instructions Manual

5 Machine Data Dialog (MDD – as from SW 3)

5.8.2 2nd level: Configuring the individual machine data areas (as from SW 3)

5.8.2
Explanation
5–34
More user manuals on
In the case of "Save all" the NQEC parameterization including the measured val-
ues from the NCK/servo are read out and stored in ASCII files under the selected
name.
In the case of "Load all", the selected NQEC ASCII files are read in and stored as
boot files. A backup mechanism which is similar to that of TEA2-Load-all is imple-
mented which is able to recover the NQEC boot files automatically on a power
failure, emergency stop, if the hard disk is full or the abort key has been operated
etc.
New alarms for this function: 165051 to 165054.
2nd level: Configuring the individual
machine data areas (SW 3 and higher)
Drive machine data (TEA3)
NC machine data (TEA1)
General Geometry
NC MD motion
Memory
config.
PLC machine data (TEA2)
I/O device Alarms
setting messages
Cycle machine data (TEA4)
Central Chan. dep.
cycle MD cycle MD
Interpolation compensation machine data (IKA1 – IKA3)
IKA con- IKA curve
figuration pointer
On the 2nd level the file functions refer to the data of the individual machine data
areas. If the same file names are assigned to data records in different areas, they
appear on the first level (machine configuration) under one data selector and can
be loaded together from there.
ManualsBase.com
Axis Spindle
(FDD) (MSD)
Channel Axis Spindle
PLC basic User Tool
data MD manage-
ment
IKA error
points

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
File
functions
Gearbox File
interpol. functions
"
Computer File
link functions
File
functions
File
functions
SINUMERIK 840C (IA)